Removal 34 High Voltage Power Supply (Pl5.1.17) - Dell 3130cn Service Manual

Removal 34 HIGH VOLTAGE POWER SUPPLY (PL5.1.17)

Use a wristband to protect the PWB from electrostatic damage.
Steps 1 through 8 are for reference. Before removing this component, check that Steps 1 through 8
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the LEFT COVER. (Removal 20)
6) Remove the TOP COVER. (Removal 31)
7) Remove the SHIELD ASSY ESS. (Removal 25)
8) Remove the SHIELD MCU. (Removal 27)
9) Disengage the connector (P/J16) of the HIGH VOLTAGE POWER SUPPLY (PL5.1.17) on the
MACHINE CONTROL UNIT (PL9.1.20), and then pass the connector through the hole on the
SHIELD REAR (PL9.1.11).
Continues to the next page.
Version 1 2008.01.08
Chapter 3 Removal and Replacement Procedures (RRPs)
9)-3
9)-2
9)-1
3 - 60
Zna03045KA