Fip1.34 Paper Jam - Dell 3130cn Service Manual

FIP1.34 Paper Jam 072-100

Step
Possible causative parts:
ROLL ASSY TURN (PL12.3.4)
ROLL ASSY FFEED (Feed Roll) (PL12.3.29)
ROLL ASSY FEED (Nudger Roll) (PL12.3.29)
550 OPTION FEEDER (PL12.1.1)
SENSOR PHOTO (REGI SENSOR) (PL3.2.30)
CLUTCH ASSY FEED OPT (PL12.1.6)
CLUTCH ASSY TURN OPT (PL12.1.5)
HARN ASSY REGI SNR (PL3.2.37)
HARN ASSY R SIDE (PL10.1.15)
HARN ASSY C2 MOT (PL12.2.9)
HARN ASSY FDR UNIT (PL12.2.3)
HARN ASSY C2 CHUTE(PL12.2.7)
HARN ASSY C2 TURN(PL12.2.8)
PWBA OPT FDR (PL12.2.6)
PWBA MCU (PL9.1.20)
DRIVE ASSY OPT FDR(PL12.2.10)
Checking the paper condition
1
Is the paper in the Tray wrinkled or damaged?
Checking the paper size setup
2 Does the paper size in use match the size setup set
through the control panel?
3 Does the error still occur when printing?
Checking after reseating the CASSETTE ASSY 550 OPT
4 Reseat the CASSETTE ASSY 550 OPT.
Does the error still occur when printing?
Checking the SENSOR PHOTO (REGI SENSOR) for oper-
ation
Does the number on the screen increase by one, every
5 time the actuator of the SENSOR PHOTO (REGI SEN-
SOR) is operated?
Checked by [Digital Input] - [DI-3(Control Panel)/REGI
SNR(PC)] in diagnosis.
Checking the DRIVE ASSY OPT FDR for operation
Does the DRIVE ASSY OPT FDR operate properly?
6
Checked by [Digital Output] - [DO-19(Control Panel)/
OPTION FEEDER1 MOTOR ON(PC)] in diagnosis.
Checking the CLUTCH ASSY PH FEED for operation
Does the CLUTCH ASSY PH FEED operate properly?
7
Checked by [Digital Output] - [DO-31(Control Panel)/
CASSETTE2 FEED CLUTCH ON(PC)] in diagnosis.
Checking the CLUTCH ASSY PH TURN for operation
Does the CLUTCH ASSY PH TURN operate properly?
8
Checked by [Digital Output] - [DO-33(Control Panel)/
CASSETTE2 TURN CLUTCH ON(PC)] in diagnosis.
Version 1 2008.02.15
Check
1 - 215
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new
and dry one, then
go to step 2.
Correct the paper
size through the
Go to step 3.
then go to step 3.
Go to step 4.
Go to step 5.
Go to step 6. Go to step 11.
Go to step 7. Go to step 16.
Go to step 8. Go to step 23.
Go to step 9. Go to step 30.
No
Go to step 2.
control panel,
End of work
End of work