FIP1.8 006-370 Restart Printer
Step
Possible causative parts:
ROS ASSY (PL13.3.12)
PWBA MCU (PL13.5.13)
Checking the ROS ASSY for installation
1
Is the ROS ASSY installed correctly?
2
Does the error still occur when the power is turned ON?
Checking the connector for connection
3
Check the connection the PWBA MCU.
Are P/J12 and P/J151 connected surely?
4
Does the error still occur when the power is turned ON?
Checking the PWBA MCU for installation
5
Is the PWBA MCU installed correctly?
6
Does the error still occur when the power is turned ON?
Checking after replacing the ROS ASSY
Replace the ROS ASSY. (Refer to Removal 36/Replace-
7
ment 8)
Does the error still occur when the power is turned ON?
Version 1 2008.02.15
Check
1 - 184
Chapter 1 Troubleshooting
Yes
Reseat the ROS
Go to step 3.
ASSY, then go to
Go to step 3.
Go to step 5.
then go to step 4.
Go to step 5.
Reseat the PWBA
Go to step 7.
MCU, then go to
Go to step 7.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
No
step 2.
End of work
Reconnect the
connector(s)
P/J12 and/or
P/J151 surely,
End of work
step 6.
End of work
End of work