Dell 3130cn Service Manual page 42

Error Message
LCD
010-354
Restart Printer
Flip
Contact Support
IfMessageReturns
010-377
Restart Printer
Flip
Reseat Fuser
Contact Support
016-300
Restart Printer
Flip
Contact Support
IfMessageReturns
016-301
Restart Printer
Flip
Contact Support
IfMessageReturns
Version 3 2008.05.30
Status Window
Printer error.
Turn off the printer, and turn it
on again.
Contact customer support if
this failure is repeated.
010-354
Printer error.
Turn off the printer. Confirm
Fuser is correctly installed.
Turn on the printer.
Contact customer support if
this failure is repeated.
010-377-01(or 02 to 13)
*1: The error code number varies depending on the error contents.
01: "NC circuit fail error"
02: "NCD snap out error"
03: "NCD fail error"
04: "NCC snap out error"
05: "NC comp fail error"
06: "NC-STS temp over error"
07: "STS-NC temp over error"
08: "NC comp fail error"
09: "NC overheat error"
0A: "STS snap out error"
0B: "STS overheat error"
0C: "Low temp1 error"
0D: "Low temp2 error"
0E: "Timeout 1 error"
0F: "Timeout 2 error"
10: "Timeout 3 error"
11: "Relay cutoff 1 error"
12: "Relay cutoff 2 error"
13: "Relay cutoff 3 error"
Printer error.
Turn off the printer, and turn it
on again.
Contact customer support if
this failure is repeated.
016-300
Printer error.
Turn off the printer, and turn it
on again.
Contact customer support if
this failure is repeated.
016-301
Error Contents
<IOT environment Sensor Error>
Temperature Sensor Error is detected.
<IOT Fuser Failure>
The NC sensor circuit is defective in the
MCU.
NC: No Contact
Pressing three keys (< > + < > + < >)
shows detail error code.
Line1 010-377
*1
Line2 Code:01(or 02 to 13)
<ESS Data Cache Error>
CPU data cache error.
<ESS Instruction Cache Error>
CPU instruction cache error.
1 - 16
Chapter 1 Troubleshooting
FIP to be
referred
Flows 23
FIP1.23
*1
Flows 24
FIP1.24
Flows 25
FIP1.25
Flows 25
FIP1.25