Fip1.12 007-340-03 Restart Printer - Dell 3130cn Service Manual

FIP1.12 007-340-03 Restart Printer

Step
Possible causative parts:
FEEDER ASSY (PL3.2.1)
PWBA MCU (PL9.1.20)
HARN ASSY R SIDE (PL10.1.15)
DRIVE ASSY PH (PL8.1.7)
Checking the detail error code.
A detailed error code is displayed by pushing
1
and key simultaneously.
Is "Code:03" displayed on the LCD?
Checking the ROLL REGI RUBBER for rotation
Does the ROLL REGI RUBBER rotate smoothly?
2
Check the rotation of the ROLL REGI RUBBER with a fin-
ger.
Checking the connectors for connection
Check the connections between the PWBA MCU and
3
DRIVE ASSY PH.
Are P/J25 and P/J251 connected surely?
Checking the PH Motor for rotation
Does the PH Motor function normally?
4 Checked by [Digital Output] - [DO-a(Control Panel)/PH
MOTOR ON(PC)] in diagnosis. During the test, close the
Front Cover.
Checking the DRIVE ASSY PH for installation
5
Is the DRIVE ASSY PH installed correctly?
6 Does the error still occur when the power is turned ON?
Checking the connectors of the DRIVE ASSY PH for con-
nection Check the connections between the PWBA MCU
7
and DRIVE ASSY PH.
Are P/J25 and P/J251 connected surely?
Checking the HARN ASSY R SIDE for continuity Discon-
nect P/J25 from the PWBA MCU.
8
Disconnect P/J251 from the DRIVE ASSY PH.
Is each cable of P/J25 <=> P/J251 continuous?
Checking the power to DRIVE ASSY PH Disconnect the
connector of P/J25 on the PWBA MCU.
9 Are the voltages across ground <=> J25-1pin/J25-2pin on
the PWBA MCU, about +24 VDC when the interlock switch
(HARN ASSY INTERLOCK) is pushed?
Version 3 2008.05.30
Check
key,
1 - 188
Chapter 1 Troubleshooting
Yes
key
Go to step 2.
Go to step 3.
Go to step 4.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 6.
Go to step 7.
Go to step 8.
Go to step 9.
Replace the
DRIVE ASSY PH.
(Refer to Removal
17/Replacement
27)
No
"00":Go to FIP1.9.
"01":Go to
FIP1.10.
"04":Go to
FIP1.13.
Replace the
FEEDER ASSY.
Reconnect the
connector(s)
P/J25 and/or
P/J251 surely,
then go to step 4.
Go to step 5.
Reseat the
DRIVE ASSY PH,
then go to step 6.
End of work
Reconnect the
connector(s)
P/J25 and/or
P/J251 surely.
Replace the
HARN ASSY R
SIDE.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)