Removal 36 Ros (Pl5.1.99) - Dell 3130cn Service Manual

Removal 36 ROS (PL5.1.99)

Steps 1 through 9 are for reference. Before removing this component, check that Steps 1 through 9
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the LEFT COVER. (Removal 20)
6) Remove the TOP COVER. (Removal 31)
7) Remove the SHIELD ASSY ESS. (Removal 25)
8) Remove the SHIELD MCU. (Removal 27)
9) Remove the FAN. (Removal 32)
hook
10) Raise the DUCT AIRFLOW (PL9.1.41) slightly until its tab is released from the hole on the
SHIELD LVPS(PL9.1.9), and then move the DUCT AIRFLOW rearward until its two hooks
are released.
11) Remove the DUCT AIRFLOW from the printer.
Continues to the next page.
Version 3 2008.05.30
10)-2
10)-1
hook
tab
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 66
11)
Zna03234KA