Replacement 11 HARN ASSY AC IN (PL9.1.16)
3)
3)
3)
1)
Pass the HARN ASSY AC IN into the inside of the printer, through the notch of the printer.
When replacing the POWER SWITCH, match the ON/OFF mark of the POWER SWITCH
with the mark on the FRAME.
2)
Replace the POWER SWITCH to the printer, and secure with the hook.
The delta mark is stamped on each clamp mounting hole of SHIELD REAR.
3)
Attach the four clamps to the holes on the SHIELD LVPS and the SHIELD REAR.
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
3)
1)
3 - 119
NOTE
2)
Zna03310KB