Fip1.10 007-340-01 Restart Printer - Dell 3130cn Service Manual

FIP1.10 007-340-01 Restart Printer

Step
Possible causative parts:
PWBA MCU (PL9.1.20)
HARN ASSY R SIDE (PL10.1.15)
DRIVE ASSY MAIN (PL8.1.2)
Checking the detail error code.
A detailed error code is displayed by pushing
1
and key simultaneously.
Is "Code:01" displayed on the LCD?
Checking the print cartridges for installation
2
Are the Y, M, C and K print cartridges installed correctly?
3 Does the error still occur when the power is turned ON?
Checking the connectors for connection
Check the connections between the PWBA MCU and
4
DRIVE ASSY MAIN.
Are P/J22 and P/J221 connected surely?
Checking the Sub Motor in the DRIVE ASSY MAIN for
rotation
Does the Sub Motor function normally?
5
Checked by [Digital Output] - [DO-5(Control Panel)/SUB
MOTOR(PC)] in diagnosis. During the test, close the Front
Cover.
Checking the DRIVE ASSY MAIN for installation
6
Is the DRIVE ASSY MAIN installed correctly?
7 Does the error still occur when the power is turned ON?
Checking the connectors of the Sub Motor on the DRIVE
ASSY MAIN for connection Check the connections
8
between the PWBA MCU and DRIVE ASSY MAIN.
Are P/J22 and P/J221 connected surely?
Checking the HARN ASSY R SIDE for continuity Discon-
nect P/J22 from the PWBA MCU.
9
Disconnect P/J221 from the DRIVE ASSY MAIN.
Is each cable of P/J22 <=> P/J221 continuous?
Checking the power to DRIVE ASSY MAIN Disconnect the
connector of P/J22 on the PWBA MCU.
10 Are the voltages across ground <=> J22-A2pin/J22-A4pin
on the PWBA MCU, about +24 VDC when the interlock
switch (HARN ASSY INTERLOCK) is pushed?
Version 3 2008.05.30
Check
key,
1 - 187
Chapter 1 Troubleshooting
Yes
key
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 5.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 7.
Go to step 8.
Go to step 9.
Go to step 10.
Replace the
DRIVE ASSY
MAIN. (Refer to
Removal 38/
Replacement 6)
No
"00":Go to FIP1.9.
"03":Go to
FIP1.12.
"04":Go to
FIP1.13.
Reseat the print
cartridge(s),
then go to step 3.
End of work
Reconnect the
connector(s)
P/J22 and/or
P/J221 surely,
then go to step 5.
Go to step 6.
Reseat the
DRIVE ASSY
MAIN, then go to
step 7.
End of work
Reconnect the
connector(s) P/
J22 and/or P/J221
surely.
Replace the
HARN ASSY R
SIDE.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)