Fip-1.P12 Skew - Dell 3130cn Service Manual

FIP-1.P12 Skew

Mnt01116KA
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the paper condition
1
Is the paper in the tray new and dry one?
Checking the Front Cover latching
2 Open and close the Front Cover.
Does the error still occur when printing?
Checking the foreign substance
Open the Front Cover, check the surrounding area of the
3
print cartridges, the TRANSFER ASSY and the Regi Rolls.
Are there any foreign substances?
Checking the surface of TRANSFER ASSY.
4 Are there any damages on the surface of TRANSFER
ASSY?
Checking the skewed tray
5
Is the skewed paper the MPF fed?
Checking the paper installation. Reseat the paper and
6 reset the paper guide on the MPF.
Does the error still occur when printing?
Checking the paper
7
Is the MPF feeding the envelope?
Checking the envelope setting
8 Was the envelope inserted with the flap closed, air vacu-
umed, and short edge facing toward the printer?
Checking the paper path.
9
Is there the foreign substance on the paper path?
Version 2 2008.03.27
Trouble substance
The printed image is not paralleled with both sides of the paper.
Possible causative parts
- SEPARATOR ROLLER ASSY MSI (PL2.1.3)
- KIT SEPARATOR and FEED ROLLER (PL2.2.99)
- ROLL ASSY FEED MSI (PL3.1.10)
- KIT FEEDER ASSY (PL3.2.99)
- TRANSFER ASSY (PL4.1.1)
- FEEDER ASSY DUP (PL11.1.1)
- KIT SEPARATOR and FEED ROLLER (PL12.3.99)
Check
1 - 309
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new
and dry one.
Go to step 3.
Remove the for-
eign substances.
Replace the
TRANSFER
ASSY. (Refer to
Removal 4/
Replacement 40)
Go to step 6. Go to step 12.
Go to step 7.
Go to step 8.
Reseat the enve-
Go to step 9.
Remove the for-
Go to step 10.
eign substance.
No
Go to step 2.
End of work.
Go to step 4.
Go to step 5.
End of work.
Go to step 9.
lopes.