Removal 14 FRONT COVER (PL1.2.98)
The procedures described below must be performed with the MPF COVER (PL1.2.24)
attached to the FRONT COVER (PL1.2.1).
Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 10)
4)
Remove the RIGHT COVER. (Removal 11)
5)
Remove the one screw (silver, with washer, 6mm) that fixes to the printer the ground wire of
the HARNESS ASSY FRONT COVER (PL1.2.11).
When performing the step below, leave the junction connector on the printer side
cable.
6)
Disengage the connector (P/J2900) of the HARNESS ASSY OPEPANE (PL1.2.15) and the con-
nector (P/J272) of the HARNESS ASSY FRONT COVER.
7)
Release the HARNESS ASSY OPEPANE and the HARNESS ASSY FRONT COVER from the
DUCT ASSY DRV PH (PL8.1.8).
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
6)
7)
3 - 24
5)
Zna03025KB