Removal 19 Breaker Gfi Inlet (Pl9.1.43) - Dell 3130cn Service Manual

Removal 19 BREAKER GFI INLET (PL9.1.43)

Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Disengage the connector (P/J482) and the FASTON terminal (FS483) on the BREAKER GFI
INLET (PL9.1.43).
6) Remove the two screws (silver, tap, 16mm) that fix the BREAKER GFI INLET to the printer.
7) Remove the BREAKER GFI INLET from the printer.
Version 1 2008.01.08
Chapter 3 Removal and Replacement Procedures (RRPs)
5)
5)
3 - 34
7)
6)
6)
Zna03202KA