Setting The Date And Time - NTT docomo FOMA SO906i User Manual

2
Set each item.
If you perform the Reset all data&set or do not change the Security code of the FOMA
terminal or settings of the Location request or All font size setting, the message "Initial
setting is incomplete. Execute?" appears when you power on the FOMA terminal. When you
select [Yes], the display in step 1 appears and you can perform the initial setting.

Setting the Date and Time

You can set the date and time either by automatically correcting the time based on the
time information obtained from the DoCoMo network or by manually setting the time.
Example: Correcting the time automatically
1
From the Menu, select [Settings]
2
Select [ON] at [Auto time adjust].
[ON] : Correct the date and time automatically.
[OFF] : Do not correct the date and time automatically. Set the time using the Manual clock
set.
To set the time manually
Select [Manual clock set]
2005/01/01 to 2050/12/31, the time in 24-hour format (00:00 to 23:59), and select time
zone. Press
When you set the Auto time adjust to [ON], the date and time are corrected automatically
when the FOMA terminal is powered on with a UIM installed. Note, however, that there may
be an error lasting several seconds. The time cannot be automatically corrected in the
following cases.
- Outside of the service area (The time may not be corrected automatically even inside the
service area depending on the radio wave condition.)
- While i- ppli is running
The date and time settings are retained even when you replace the battery pack. However,
if you leave the FOMA terminal without a battery pack or with a fully expended battery pack,
the date and time may be reset to "----/--/-- --- --:--". In this case, set the date and time once
again.
If the date and time are not set, functions that use the clock, such as the current time icon,
Schedule, Alarm, Booking program, Timer recording, i- ppli Auto-start, and calendar/clock
display cannot be used. The date and time for the Redial/Received record and the date and
time on images shot with the camera are also not recorded.
When you receive time correction information from the network of the carrier to which the
FOMA terminal is connected during international roaming, the time is automatically corrected
when the Auto time adjust is set to [ON].
When the time is corrected to the local time, the date and time used for the Redial/Received
record and sent/received mail also are corrected to the local time and "
however, that some overseas networks may not perform time correction.
[Auto time adjust] : Set the time automatically.
[Manual clock set] : Enter the time manually. When you set the time
[Yes] and enter the year and date within the range from
(Complete).
[Management]
using the Manual clock set, the Auto time adjust is
set to [OFF].
<Date/time>
[Date/time] and press
" appears. Note,
.
49