Table of Contents
Advertisement
1
If you subscribe to the Call Waiting Service, you can place a call to another recipient while
you already have a call in progress.
2
If you subscribe to the Call Waiting Service, you can receive another call while you already
have a call in progress. If you do not yet subscribe to the Call Waiting Service, you can
receive another call after you disconnect the first call.
3
You can place a voice or videophone call or originate a PushTalk call after disconnecting
the current communication.
4
The FOMA terminal does not perform the receiving operation and a received call is saved
in the Received record as a missed call.
5
If you do not yet subscribe to the Voice Mail Service, Call Waiting Service, or Call
Forwarding Service, a received call is not saved in the Received record.
6
In either of the following cases, the FOMA terminal notifies you of an incoming voice call
and you can select either to "answer a voice call" or to "continue with PushTalk call". (The
one that was not selected is terminated.)
When the P-Talk arrival act is set to [Answer]
When the P-Talk arrival act is set to [Voice Mail] or [Call Forwarding] and you do not
subscribe to these services
7
If you originate a PushTalk call, you can place another call to add a member.
8
The FOMA terminal performs the operation set by the V.ph while packet.
When the V.ph while packet is set to [Prefer packet] or when the V.ph while packet is set
to [V.ph voicemail] or [Call forwarding] and you do not subscribe to these services, the
packet communication is continued.
When the V.ph while packet is set to [Prefer V.phone], packet communication is
disconnected and you can receive a videophone call.
9
The FOMA terminal performs the operation set by the i-mode arrival act.
When set to [Prefer i-mode], i-mode communication is continued.
When set to [Prefer PushTalk], i-mode communication is disconnected and you can
receive a PushTalk call.
10 While you are performing i-mode communication using i- ppli, you can send data after
disconnecting the i-mode communication in progress.
11 A combination of the same communication direction, either sending or receiving, is not
available.
12 When you set the Host selection to [i-mode(UIM)], " " appears.
13 After the current communication is terminated, the Full Browser communication is started.
14 When switching from i-mode to Full Browser, after the i-mode communication is terminated,
the Full Browser communication is started.
15 You can only place a call by entering a phone number directly in the stand-by display.
457
Advertisement
Chapters
Table of Contents
