Table of Contents
Advertisement
Composing/Sending Mail from
the Current Display
You can compose/send mail to a mail address
currently displayed in the display (Mail To).
When 2in1 is set to the B mode, you cannot use the
Mail To function.
1
Select a mail address in the display and
press
.
The Edit mail display appears.
The selected mail address is entered as the
address.
2
Compose mail and send it.
Follow the same steps as in "Compose and send
mail" (P.183, step 4 to 6).
Accessing a Site from the
Current Display
You can connect to a site by i-mode of Full
Browser from a URL currently displayed in the
display (Web To).
1
Select a link (URL) in the display and
press
.
The FOMA terminal is connected to the linked site.
Depending on a link setting, the message
informing to switch the i-mode site to Full
Browser may appear. To display a site by Full
Browser, select [OK].
Running i- ppli from the
Current Display
You can start i-
ppli software from a link
currently displayed in the display. The
software can also be started using the infrared
communication (i- ppli To).
Download software that can be started by the
i- ppli To beforehand.
i- ppli cannot be started to run when the i- ppli To
is set to [No] (P.222).
1
Select i-
ppli link in the display and
press
.
The screen for confirming whether to start i- ppli
appears.
Some software may be activated without
displaying the screen for confirming whether to
start software.
2
Select [Yes] and press
The software is started to run.
Activating 1Seg from the
Current Display
You can activate 1Seg or set a timer for
watching/recording a 1Seg program from a
program information link currently displayed in
the display (Media To).
1
Select a program information link in the
display and press
T h e d i s p l a y f o r 1 S e g w a t c h i n g o r b o o k i n g
reservation appears.
Follow the same steps as in "Watching 1Seg"
(P.269) or "Setting a Timer for Watching/
Recording a 1Seg Program (P.276, step 4 to 5).
Even if the link is highlighted, the Media To may
not be used.
Setting i-mode
Setting the Connection Timeout
The duration before disconnecting the FOMA
terminal automatically can be set when you
cannot send or receive data due to heavy
traffic at the i-mode center.
1
From the i-mode menu, select [i-mode
s e t t i n g ]
[ C o m m o n s e t t i n g ]
[Connection timeout] and press
[60sec]:
Disconnect automatically when unable to send/
receive data for 60 seconds.
[90sec]:
Disconnect automatically when unable to send/
receive data for 90 seconds.
[Unlimited]:
Do not set the connection timeout (however, the
connection can be disconnected due to the radio
wave condition or other reasons).
2
Select the waiting duration and press
The Connection timeout is set.
.
.
<i-mode setting>
.
.
Continued
173
Advertisement
Chapters
Table of Contents
