NTT docomo FOMA SO906i User Manual page 148

4
Press (Save).
The composed panorama image is saved.
After the shutter sound is heard, do not move
the camera while the message "Photographing.
Wait for a while" remains displayed. Failure not
to do so may cause the composed image to
be extremely compressed vertically or failure in
composition.
Once you press the shutter key to start recording
a panorama image, the Camera mode is not
terminated even if no operation is made for over
two minutes.
Recording Still Images in the
Continuous Mode
You can record four still images continuously at
an interval of about 0.2 seconds with a single
press of (Shoot) or
 The image size in the Continuous mode is [VGA(640
480)]. You cannot change the image size.
 When you set the Shoot mode to [Continuous mode]
while the Select scene is set to [Night scene] or [Low
Light], the Select scene is changed to [AUTO].
1
Press (Func) in the Camera mode
display, select [
[ ] (Continuous mode), and press
2
Press (Close).
The Shoot mode is set to [Continuous mode] and
" " appears.
146
.
] (Shoot mode)
.
3
Point the camera at the object and press
(Shoot).
The white focus frame is used to adjust the focus.
When the image comes into focus, the confirmation
sound is heard, and the focus frame turns green.
Images are recorded continuously with the burst
sound, and the screen for confirming whether to
save the images appears.
4
Press (Save).
Four continuous images are saved.
 Continuous images cannot be attached to mail or
posted on a blog by selecting at the screen for
confirming whether to save images.
Recording Images with Frames
You can record an image with a frame, which
can be selected from the preinstalled frames
or downloaded frames.
 For Out-camera recording, you can select a frame
size of [QCIF(176 144)], [QVGA(240
[VGA(640 480)], and [Stand-by(480 864)]. For
In-camera recording, you can select the frame
size of [QCIF(176 144)], [QVGA(240 320)], and
[VGA(640 480)].
 The size of images recorded with a frame is
determined according to the frame you selected
and cannot be changed.
1
Press (Func) in the Camera mode
display, select [
[ ] (Shoot with frame), and press
2
Select a frame size and press
The Frame display appears.
3
Select a frame and press
The Shoot mode is set to [Shoot with frame] and
" " and the selected frame appear.
To check a frame
Move the cursor to a frame and press
320)],
] (Shoot mode)
.
.
.
(Play).