NTT docomo FOMA SO906i User Manual page 109

6
Select a vibration pattern at [Vibrator].
[Pattern1]:
Set a short intermittent vibration.
[Pattern2]:
Set a long intermittent vibration.
[Link melody]:
Set vibration to be synchronized with the
positioning tone. When you set the positioning
tone to [Silent] or the melody which cannot be
synchronized is set, [Pattern1] is used.
[OFF]:
Do not set the vibrator.
To check the vibration
Move the cursor to the vibration pattern and
press (Confirm).
7
S e l e c t [ O N ] / [ O F F ] o f t h e i n c o m i n g
indicator at [Color].
 You can set the incoming indicator to the Position
location and Location notice functions.
8
Select an indicator color at [Color].
Select from 12 colors plus [C13:ALL] (in which the
12 colors flash in turn).
When you move the cursor through the colors, the
incoming indicator flashes accordingly.
9
Press (Complete).
The tone/indicator color while using the GPS
function is set.
Setting the Poor Signal
Quality Alert
You can set to inform you with alarm of the
possibility of the call being disconnected
during a voice call due to the radio wave
condition.
1
From the Menu, select [Settings]
[Call quality]
press .
[High]:
Sound a high alarm tone.
[Low]:
Sound a low alarm tone.
[OFF]:
Do not sound an alarm tone.
<Quality alarm>
[Call]
[Quality alarm] and
2
Select the type of alarm tones and press
.
The Quality alarm is set.
If the radio wave condition becomes weak
suddenly, the call may be disconnected with no
alarm.
Setting Earphone Only for
the Ring Tone
You can set the position where the ring
tone sounds when the Flat-plug Earphone/
Microphone with Switch (optional) is connected
to the FOMA terminal. The other tones, such as
the Alarm/Schedule alarm/Booking alarm tones
also sound from the position you set for the
ring tone.
 Even if [Headset only] is set, the ring tone of a voice,
videophone, or PushTalk call sounds from both the
earphone and speaker about 20 seconds later after
it starts sounding.
1
From the Menu, select [Settings]
[Headset setting]
setting] and press
[Headset only]:
The tone sounds only from the earphone.
[Headset+speaker]:
The tone sounds from both the earphone and the
speaker.
2
Select [Headset only] and press
The tone sounds only from the earphone.
Changing the Ringing
Sound
You can change the ringing sound which a
caller hears to a melody with sense of the
season or popular music, etc.
 This service is a paid service that requires a
subscription. For more details about this service,
see the "Mobile Phone User's Guide Network
services ".
1
From the Menu, select [Settings]
[Melody Call] and press
The screen for confirming whether to connect a site
appears.
<Headset usage setting>
[Call]
[Headset usage
.
.
<Melody Call>
[Call]
.
Continued
107