Introduction Of Movie Player Software; Troubleshooting - NTT docomo FOMA SO906i User Manual

Introduction of Movie Player Software

To play back a movie (MP4 format file) on a PC, you need QuickTime Player (free) ver.
6.4 or later (or ver. 6.3+3GPP) from Apple Computer, Inc.
You can download QuickTime from the following website.
http://www.apple.com/jp/quicktime/download/
 To download this software, you need a PC connected to the Internet. A separate communication
charge is also required for downloading.
 Check the above website for details about the operating environment, downloading method,
operation method, and other information.

Troubleshooting

First, check if the software update is necessary for the FOMA terminal. If necessary,
perform the software update (P.473).
Trouble
Cannot power on the FOMA terminal.
(The FOMA terminal cannot be used.)
The warning tone sounds and does not
stop even when you press the Power key,
and the FOMA terminal is powered off.
The busy tone sounds and the
call is not connected, even if you
dial up.
" " is displayed and the busy
tone sounds.
Cannot place a call even if you
press the keypad.
The dark display appears and
cannot operate anything.
The set stand-by display does not
appear and the dark display appears.
Text is displayed in Japanese.
Cannot receive a call or the ring
tone does not sound.
The mail and alarm tones sound
but the ring tone for an incoming
call does not sound.
The mail tone sounds but there is
no incoming mail.
 Check if the battery pack is attached properly (P.43).
 Check if the battery pack is not run out (P.47).
 The battery is running out. Charge the battery (P.46).
 Check if "
" appears (P.31).
 Check if you enter the area code (P.55).
 Check if you dial up in a hurry without hearing the ringing tone (P.55).
 Check if you are outside of the service area or in a location with
weak radio wave condition (P.31).
 Check if the Self mode is set (P.127).
 Check if the Key dial lock is set (P.129).
 Check if the FOMA terminal is powered on (P.48).
 Check if the Power saver mode is set (P.116).
 Check if the Select language is set to [Japanese] (P.120).
 Check if the Public mode (Drive mode) is set (P.70).
 Check if the Ring volume is set to [OFF] (P.103).
 Check if the Manner mode is set (P.108).
 Check if the Self mode is set (P.127).
 Check if the Accept/Reject call is set (P.133).
 Check if the Denied no ID is set (P.134).
 Check if the Set ring start time is set (P.134).
 Check if the Reject unknown is set (P.135).
 Check if the ring time of the Voice Mail/Call Forwarding Service is
set to 0 seconds (P.410, 412).
 Check if the Caller ID Request is set (P.413).
 Check if the Mova terminal is enabled for the Dual Network Service (P.413).
 Check if the Ring volume is set to [OFF] (P.103).
 Check if a longer interval (such as 99 sec) is set at [Start time] of
the Set ring start time. Set it to a shorter interval (P.134).
 Check if the Tone/Vibrate notice of the Voice Mail Service is set to
[ON]. If it is ON, you are notified of the increase in the number of
record messages by the mail tone (P.410).
Cause and Remedy
461
Continued