Setting Date And Time - NTT docomo FOMA P906i Instruction Manual

<Initial Setting>
Executing Initial Settings
If the date and time, Terminal Security Code, Keypad Sound, Location
Request Menu, or Character Size is not set, the Initial Setting display
appears when you turn on the power. You can set the initial settings also
from each menu function separately.
1
Turn on the powerYES
pWhen the display for entering your Terminal Security
Code, PIN1 code, or PIN2 code appears, follow the
operation on page 45.
2
Set the date and time.
You can select "Auto time adjust ON" or "Auto time adjust OFF" for setting the time.
(See page 46)
3
Set your Terminal Security Code.
You can set your Terminal Security Code required for setting functions.
(See page 132)
1. Enter "0000"Enter your new Terminal Security Code (four to eight digits)
YES
4
Set Keypad Sound.
You can set the keypad whether to make a sound. (See page 111)
5
Set Location Request Menu.
You can set whether to notify your current location for when a GPS location
provision request arrives. (See page 288)
6
Set the size of characters.
You can set the size of characters on the display at a time. (See page 129)
Information
pWhen an unset function is found, the Initial Setting display for the unset function
appears each time you turn on the power.
46
Information
pThe completed settings are valid even when total setting is interrupted by an incoming
- h or
call or canceled by pressing
pWhen the power is automatically turned on by alarm notification, the Initial Setting
display does not appear even if there is any unset function.
pWhen you finish the initial settings, the confirmation display appears telling that
updating software is executed automatically. This display appears only at the first
time, and after that, does not appear until you execute Reset Settings or Initialize.
<Set Time>

Setting Date and Time

You can select whether to correct the time automatically or set it
manually. The time is set/displayed on the 24-hour basis.
1
mSettingsClockSet timeAuto time adjust ON
or Auto time adjust OFF
Auto time adjust ON
. . . . Corrects the date/time automatically. The setting is completed.
When the time cannot be corrected automatically such as when "
displayed and the date/time has not been set, the Manual Time Setting
display appears. Follow step 2 to set the date/time.
Auto time adjust OFF
. . . . Sets the date/time manually.
pWhen "Notice call cost" is set to "ON", you need to enter your Terminal Security
Code.
2
Enter year, month, date and time.
o to move the cursor and enter numbers by the M
Use
numeric keys.
pTo enter one-digit numeral for the date and time, enter
two digits beginning with "0" as in "01" through "09".
pHighlight "time zone" and press l(
o to select a region and press M
time zone. Use
r midway. -
m + 3 -
) to set the
o ( O
).
- 1
" is