Table of Contents
Advertisement
At the Booking Alarm Time
The alarm tone sounds for about 30 seconds
with the indicator flashing.
To stop the alarm tone
Press any key. When you stop the alarm tone,
the display informing the release of the alarm
appears. To turn off the display, press
.
When you do not stop the alarm tone
The display informing the release of the alarm
appears. To turn off the display, press
.
When the Cfm. activation is set to [ON]
After you turn off the display informing the
release of the alarm, the Cfm. activation display
appears. Select [Yes] to activate 1Seg.
When the Cfm. activation is set to [OFF]
Press
for over a second to activate 1Seg.
If you set an i-motion with video and sound
tracks to the alarm tone, a movie in the i-motion
is displayed.
I f t h e a l a r m t i m e c o m e s d u r i n g a v o i c e /
videophone call or PushTalk communication,
the default alarm tone sounds and default
alarm image is displayed. The vibrator does not
operate.
The Booking alarm does not operate in the
following cases.
- When the FOMA terminal is powered off
- While the Lock all is set
- While the Omakase Lock is set
- While updating the software
278
If the alarm time comes in the following cases,
the alarm may operate when the status changes
to during a call or stand-by.
- While placing/receiving a voice/videophone
call or originating/receiving a PushTalk call
- During packet communication
- During the infrared communication/while the
infrared remote control is being used
- During the iC communication
- During data communication or while reading/
writing data from/into a microSD card on a PC
with the FOMA terminal connected using the
USB cable
- While recording a still image/movie
- While the Schedule alarm is sounding
- B e e p w h i l e re c e i v i n g A re a M a i l , w h i l e
sounding Area Mail ring tone, or displaying
Area Mail
If you leave the FOMA terminal with the battery
pack removed or fully expended for a long
(OK) or
period of time, the date and time is reset, and the
Booking alarm may not operate correctly.
(OK) or
At the Timer Recording Starting Time
A recording is automatically started. When
the timer for recording a program starts while
1Seg is not activated, "
recording is completed, the notification icon
"
" (Timer Rec result) appears in the stand-by
display.
Extend the 1Seg Antenna fully while recording a
program.
To check the reservation result
Press
" ".
" appears. After the
(Link) in the stand-by display and select
Advertisement
Chapters
Table of Contents
