Connecting The Foma Terminal To A Pc; Installing The Foma Communication Configuration Files - NTT docomo FOMA SO906i User Manual

Connecting the FOMA Terminal
to a PC
Connect the FOMA terminal to a PC when they are
powered on.
 You need to set the USB mode setting of the FOMA terminal
to [Communication mode].
1
Open the external connection terminal cover.
2
Insert the external connection connector of the
FOMA USB Cable with Charge Function 01/02
(optional) into the external connection terminal of
the FOMA terminal until it clicks.
3
Connect the USB connector of the FOMA USB
Cable with Charge Function 01/02 to the USB
terminal of the PC.
The FOMA terminal is connected to the PC and " " is
displayed on the FOMA terminal.
Insert the connec-
tor horizontally
with the label side
facing up.
3
USB terminal
USB connector
Disconnecting the FOMA USB Cable with Charge
Function 01/02
1
Make sure to pull out the FOMA USB Cable with
Charge Function 01/02 horizontally while holding
the release buttons pressed.
When you remove the FOMA USB Cable with Charge
Function 01/02, " " which is displayed on the FOMA
terminal disappears.
Release buttons
Forcibly pulling out the
FOMA USB Cable with
Charge Function 01/02
may cause malfunction.
2
Pull out the FOMA USB Cable with Charge
Function 01/02 from the USB terminal of the PC.
Do not remove the FOMA USB Cable with Charge Function
01/02 during data communication. Doing so may cause
malfunction, etc.
It is after installing the FOMA communication configuration
files that " " appears on the FOMA terminal.
1
2
External
connection terminal
External connection connector
FOMA USB Cable with
Charge Function 01/02
Installing the FOMA Communication
Configuration Files
To connect the FOMA terminal to a PC using the FOMA
USB Cable with Charge Function 01/02 (optional)
and perform data communication, install the FOMA
communication configuration files from this CD-ROM.
 A user with Administrator privilege can install the software.
When Using Windows XP
1
Set "FOMA SO906i CD-ROM" in the CD-ROM drive
of the PC.
2
Click [
] under "FOMA
)" (FOMA communication configuration
files (USB drivers)).
The "SO906i_USB_Driver" folder appears.
3
Double-click [FOMAinst.exe].
The Terms of Use for FOMA SO906i USB Driver appears.
4
Check the contents and click [
the terms.
The screen for confirming the connection between the PC
and FOMA terminal appears.
When you click [
Installation is canceled.
5
Connect the FOMA terminal to the PC using the
FOMA USB Cable with Charge Function 01/02.
When you click [
Installation is canceled.
6
Click [ ].
To install the FOMA byte counter
Keep installing the software continuously.
4
]
(USB
] to accept
]
]
[