NTT docomo FOMA SO906i User Manual page 532

Ntt docomo w-cdma/gsm/gprs system mobile phone
Table of Contents

Advertisement

Easy Setup (Packet Communication)
 Note that packet communication could be expensive if you
exchange large volumes of data such as viewing sites or
Internet home pages that contain images or downloading
files.
When Using "mopera U" or "mopera"
When you use "mopera", the maximum transmission/reception
speed is 384kbps.
1
Start the FOMA PC setup software and click [
].
2
Select [
3
Select [ mopera U
] and click [
].
When you select [ mopera U
window for subscription appears. If you have already
subscribed to "mopera U", click [
4
Click [OK].
The host (APN) is loaded from the FOMA terminal. Wait for
a few moments.
5
Enter a host name (any name) at [
[
].
 You cannot enter half-width characters, "¥" "/" ":" " " "?"
"<" ">" "|" """ and "!".
 When you use either "mopera U" or "mopera", your
caller ID must be notified. Select [
[186
 "mopera U" supports both [PPP
overseas use, select [IP
for the caller ID.
 "mopera" supports only [PPP
overseas.
6
Set [
ID] and [
You can connect with [
blank.
7
Check the setting information and click [
8
Click [OK].
] and click [
].
] or [ mopera
], the confirmation
].
] and click
].
] and [IP
], and [
] and cannot be used
] and click [
ID] and [
].
When Using Other Providers
1
Start the FOMA PC setup software and click [
].
2
Select [
click [
].
3
Select [
4
Click [OK].
The host (APN) is loaded from the FOMA terminal. Wait for
a few moments.
5
Enter a host name (any name) at [
 You cannot enter half-width characters, "¥" "/" ":" " " "?"
"<" ">" "|" """ and "!".
 Select [PPP
 Select [IP
 A connection to some access points may not be
available depending on the connection type they
provide.
 About whether you should notify your caller ID, follow the
instruction of your provider.
] or
]. For
]
Advanced setting (Setting of TCP/IP)
When you click [
] and [
required as information for dialing up to your provider or
office LAN, enter the appropriate addresses according to
the provided instructions.
6
Click [
].
] left
15
] for the connection type and
] for the host and click [
] for the connection type.
] for connection type for overseas use.
], the setting window of [IP
] appears. If any entries are
(APN)
].
].
].

Advertisement

Table of Contents
loading

Table of Contents