NTT docomo FOMA SO906i User Manual page 57

Placing a Voice/
Videophone Call
Check the radio wave condition and enter a
phone number.
Example: Placing a voice call
1
Enter a phone number in the stand-by
display.
 You can enter a phone number of up to 80 digits.
 Make sure to include the area code, even for a
local call.
When you press the wrong number
Press to delete the entered digits one by
one from the right. Press
to delete all digits.
2
Press .
A r i n g i n g s o u n d i s h e a rd w h e n t h e c a l l i s
connected.
To place a videophone call
Press (V.phone). When the call is answered,
your image is sent to the recipient and the call
is switched to the hands-free operation that
allows you to hear the recipient's voice from the
speaker.
When 2in1 is set to the Dual mode
Select [Number A]/[Number B] (P.416).
When a busy tone sounds
The line is busy. Press
again after a while.
When you hear a guidance
Call again according to the guidance.
3
for over a second
to hang up and call
Press to hang up.
See P.61 for sending the Chaku-moji and P.62 for
placing a voice or videophone call by specifying
the condition.
For a voice call, you can also place it in the order
of step 2 step 1. Press
number, and the call is dialed automatically after
about five seconds.
You are charged for digital communication even
if you send a substitute image during a call.
If the videophone call is not connected, the
following messages appear in the display. The
displayed message may not correctly represent
the status of the recipient depending on the
type of the phone of the recipient or whether the
recipient has subscribed to any network service.
Message
Check The phone number is no longer
number, then in use.
redial
Busy The recipient is talking on the
phone.
(This message may appear also
during packet communication on
some recipient's terminals.)
Busy with The recipient is using packet
packet communication.
transmission
Outside of The recipient is in a place where
service area/ radio waves do not reach or the
power off phone is powered off.
Set Caller ID This message appears when the
to ON call was connected without a
Caller ID (when a call is placed
to Visual Net or other sites).
Please try This message appears when the
voice call Call Forwarding Service is set
on the recipient's phone and the
terminal to which the call was
forwarded is not equipped with
the videophone function.
(As of April 2008, this message
m a y a p p e a r a l s o w h e n t h e
Voice Mail Service is set on the
recipient's phone.)
Connection This message appears when
failed none of the above reasons apply.
Please make To view V-Live contents, visit and
your call from view an official i-mode site once,
the i-mode and then place a videophone
web page call.
Upper limit The upper limit set to the plan
has been with a Limit (Type Limit or Family
exceeded. Wide Limit) has been exceeded.
Connection
failed
and enter a phone
Description
Continued
55