Hardware Installation And Configuration; Installing Your U2000 Series Usb Power Sensor; Figure 1-7 Found New Hardware Wizard Window - Agilent Technologies U2000H Operating And Service Manual

Hardware Installation and Configuration

A. Installing your U2000 Series USB power sensor
U2000 Series offers USB plug- and- play capability, with the proficiency of
power meter and power sensor in a unit that enables users to obtain
measurement readings via N1918A Power Analysis Manager.
Follow the instructions below to install and configure the U2000 Series.
1 Connect your U2000 Series USB power sensor to the PC using the USB
2 The PC will automatically detect the connected sensor and the Found New

Figure 1-7 Found New Hardware Wizard window

3 Select Yes, this time only and click Next to proceed.
4 On the following window, select Install the software automatically
U2000 Series Operating and Service Guide
cable provided. Connect the cable's mini- B plug to your U2000 Series
sensor and the other end of the cable (type- A plug) to any USB host on your
PC.
Hardware Wizard window will appear as shown below.
(Recommended) and click Next.
Introduction 1
15