FRONT LOWER ARM
FRONT LOWER ARM REMOVAL/INSTALLATION
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly
•
cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following
procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the
sensor will not be pulled while servicing the vehicle.
1. Remove the front suspension tower bar.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1
Caliper and mounting support
2
Disc plate
3
Tie-rod end
4
Front lower arm bolt joint
(w)
RX-8 Suspension
Page 10