Audit And Security Logs - Dell S4048–ON Configuration Manual

• the internal buffer
• console and terminal lines
• any configured syslog servers
To disable logging, use the following commands.
• Disable all logging except on the console.
CONFIGURATION mode
no logging on
• Disable logging to the logging buffer.
CONFIGURATION mode
no logging buffer
• Disable logging to terminal lines.
CONFIGURATION mode
no logging monitor
• Disable console logging.
CONFIGURATION mode
no logging console

Audit and Security Logs

This section describes how to configure, display, and clear audit and security logs.
The following is the configuration task list for audit and security logs:
• Enabling Audit and Security Logs
• Displaying Audit and Security Logs
• Clearing Audit Logs
Enabling Audit and Security Logs
You enable audit and security logs to monitor configuration changes or determine if these changes affect the operation of the system in the
network. You log audit and security events to a system log server, using the logging extended command in CONFIGURATION mode.
This command is available with or without RBAC enabled. For information about RBAC, see
Audit Logs
The audit log contains configuration events and information. The types of information in this log consist of the following:
• User logins to the switch.
• System events for network issues or system issues.
• Users making configuration changes. The switch logs who made the configuration changes and the date and time of the
change. However, each specific change on the configuration is not logged. Only that the configuration was modified is logged with the
user ID, date, and time of the change.
• Uncontrolled shutdown.
Security Logs
66 Management
Role-Based Access Control.