Wall Mounted Installations - Extreme Networks Altitude 4700 Series Product Reference Manual

mounting options based on the physical environment of the coverage area. Do not mount the Access
Point in a location that has not been approved in a site survey.
Refer to the following, depending on how you intend to mount the Access Point:
Wall Mounted Installations on page 51
●
Suspended Ceiling T-Bar Installations on page 53
●
Above the Ceiling (Plenum) Installations on page 55
●

Wall Mounted Installations

Wall mounting requires hanging the Access Point along its width (or length) using the pair of slots on
the bottom of the unit and using the Access Point mounting template for the screws.
CAUTION
An Access Point should be wall mounted to concrete or plaster-wall-board (dry wall) only. Do not wall
mount an Access Point to combustible surfaces.
The hardware and tools (customer provided) required to install the Access Point on a wall consists of:
Two Phillips pan head self-tapping screws (ANSI Standard) #6-18 X 0.875in. Type A or AB Self-
●
Tapping screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
Two wall anchors
●
Wall mount template
●
Security cable (optional third part provided accessory)
●
Altitude 4700 Series Access Point Product Reference Guide
51