Ap4700>Admin(System.snmp.traps)>Show - Extreme Networks Altitude 4700 Series Product Reference Manual

CLI Reference
AP4700>admin(system.snmp.traps)>show
Shows SNMP trap parameters.
Syntax
show trap
rate-trap
Example
admin(system.snmp.traps)>show trap
SNMP MU Traps
mu associated
mu unassociated
mu denied association
mu denied authentication
SNMP Traps
snmp authentication failure
snmp acl violation
SNMP Network Traps
physical port status change
denial of service
denial of service trap rate limit : 10 seconds
SNMP System Traps
system cold start
system config changed
rogue ap detection
ap radar detection
wpa counter measure
mu hotspot status
vlan
lan monitor
DynDNS Update
wlan kerb auth failed
wwan event
For information on configuring SNMP traps using the applet (GUI), see
page 103.
498
Shows SNMP trap parameter settings.
Shows SNMP rate-trap parameter settings.
: enable
: disable
: disable
: disable
: disable
: disable
: enable
: enable
: disable
: disable
: disable
: disable
: disable
: disable
: disable
: disable
: enable
: disable
: disable
Altitude 4700 Series Access Point Product Reference Guide
"Enabling SNMP Traps" on