Extreme Networks Altitude 4700 Series Product Reference Manual page 102

System Configuration
To configure SNMP user access control for the access point:
1 Select System Configuration > SNMP Access from the access point menu tree. Click on the SNMP
Access Control button from within the SNMP Access screen.
2 Configure the SNMP Access Control screen to add the IP addresses of those users receiving SNMP
access.
Access Control List Enter Start IP and End IP addresses (numerical addresses
Add
Edit
Delete
OK
Cancel
102
only, no DNS names supported) to specify a range of user
that can access the access point SNMP interface. An
SNMP-capable client can be set up whereby only the
administrator (for example) can use a read/write
community definition.
Use just the Starting IP Address column to specify a single
SNMP user. Use both the Starting IP Address and Ending
IP Address columns to specify a range of addresses for
SNMP users.
To add a single IP address to the ACL, enter the same IP
address in the Start IP and End IP fields.
Leave the ACL blank to allow access to the SNMP
interface from the IP addresses of all authorized users.
Click Add to create a new ACL entry.
Click Edit to revise an existing ACL entry.
Click Delete to remove a selected ACL entry for one or
more SNMP users.
Click Ok to return to the SNMP Access screen. Click Apply
within the SNMP Access screen to save any changes
made on the SNMP Access Control screen.
Click Cancel to undo any changes made on the SNMP
Access Control screen. This reverts all settings for this
screen to the last saved configuration.
Altitude 4700 Series Access Point Product Reference Guide