Creating A Vpn Tunnel Between Two Access Points - Extreme Networks Altitude 4700 Series Product Reference Manual

Creating a VPN Tunnel between Two Access Points

This section describes how to define a simple configuration using two Access Points to create an IPSec
tunnel.
To create a IPSec VPN tunnel between two Access Points:
1 Ensure the WAN ports are connected via the internet
2 Select Network Configuration > WAN > VPN from the access point menu tree.
3 Enter any tunnel name (tunnel names do not need to match).
4 Enter the WAN port IP address of AP #1 in the Local WAN IP field.
5 Enter the LAN IP subnet and mask of AP #2 in the Remote Subnet and Remote Subnet Mask fields.
6 Enter the WAN port IP address of AP #2 in the Remote Gateway field.
7 Click Add to add the tunnel to the list.
8 Select the Auto (IKE) Key Exchange button.
9 Select Auto Key Settings.
10 Select ESP with Authentication and AES 128-bit. Click OK.
11 Select the IKE Settings button.
12 Select Pre Shared Key (PSK).
13 Enter the Passphrase.
Passphrases must match on both VPN devices.
14 Select AES 128-bit.
15 Select Group 2.
16 Click OK.
This will take you back to the main VPN configuration screen.
17 Click Apply to save the updates
18 Select Network Configuration > WAN > VPN > VPN Status from the access point menu tree. Check the
VPN status on the Access Point.
Altitude 4700 Series Access Point Product Reference Guide
229