Install The Access Point On A Wall Or A Flat Ceiling; Install The Access Point To A Wall With Ah-Acc-Bkt-Ax-Wl - Extreme Networks AP3000 Installation Manual

Install the Access Point on a Wall or a Flat Ceiling

Install the Access Point on a Wall or a Flat Ceiling
Before You Begin
Confirm that you have the following items:
•
An AP3000 access point
•
One AH-ACC-BKT-AX-TB mounting bracket. The bracket is used for flat surface wall
or solid ceiling installation.
•
Two M3.5 pan head wood screws and two screw-in anchors.
About This Task
Follow these steps when you install the access point on a wall or solid ceiling.
Procedure
1. Mark and drill two mounting holes.
Use the AH-ACC-BKT-AX-TB mounting bracket as a template.
2. Attach the bracket to the wall.
Use the two M3.5 pan head screws. Use push-in anchors or screw-in anchors for
drywall or plastic board installations.
3. Attach the access point to the bracket
Align the red dots on the bracket and the access point base.
4. Press and rotate the AP one-sixth turn clockwise.
The AP clicks into place on the bracket.
5. Attach the network cable and power-up the AP.
•
If you use Power over Ethernet (PoE) then attach the network cable to the ETH0
port.
•
If you use Power Sourcing Equipment (PSE), then connect the power supply and
attach the network cable to the ETH0 port.

Install the Access Point to a Wall with AH-ACC-BKT-AX-WL

Before You Begin
You need the following items:
•
AP3000
•
Three M3.5 screws and three screw-in anchors, shipped with the -WL bracket
•
One AH-ACC-BKT-AX-WL bracket
About This Task
Use the AH-ACC-BKT-AX-WL bracket when you need a 1.25 inch space between the wall
and the access point.
Procedure
1. Using the -WL bracket as a template, mark and drill mounting holes on the wall.
22 ExtremeWireless™AP3000 Access Point Installation Guide
Access Point Installation