Install The Access Point On A Wall - Extreme Networks AP5050U Installation Manual

Install the Access Point on a Wall

Procedure
1. Attach an EIO-04 metal "L" bracket on each side of the AP5050U access point using two M6 screws
for each bracket.
2. Torque the M6 screws to 35 in-lbs.
3. Use the metal "L" brackets as a template, mark four hole centers, and drill in the concrete.
4. Insert four concrete anchors into the holes without the washers and nuts.
5. Place the metal "L" bracket over the threaded anchor posts and put on the flat-washer, the spring
washer, and the nut on each anchor.
6. Torque the nuts to 60 in-lbs.
Figure 6: AP5050U Flat Surface Installation with Metal "L" Brackets
What to Do Next
Install the Plastic Service Panel on the Access Point
Install the Access Point on a Wall
Before You Begin
Combine the access point with the KT-147407-02 and KT-150173-01 for wall or flat surface installation.
Other wall install options include using the:
•
MBO-ART02 bracket
The following hardware is required when installing the access point on a flat surface using the
KT-147407-02 bracket:
•
One access point
•
Flat part of the KT-147407-02 bracket with two holes on the metal surface.
26 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050U Access Point
Note
When installing the access point flat against a surface in a location that uses ice melt, the
best practice is to apply an anti-seize material to the screws before attaching them to the
access point metal base.
on page 42.
Install the Access Point