Configuring A Cisco Vpn Device - Extreme Networks Altitude 4700 Series Product Reference Manual

NOTE
Ensure the IKE authentication Passphrase is the same as the Pre-shared key on the Cisco PIX device.
15 Select AES 128-bit as the IKE Encryption Algorithm.
16 Select Group 2 as the Diffie-Hellman Group. Click OK. This will take you back to the VPN screen.
17 Click Apply to make the changes
18 Check the VPN Status screen. Notice the status displays "NOT_ACTIVE". This screen automatically
refreshes to get the current status of the VPN tunnel. Once the tunnel is active, the IKE_STATE
changes from NOT_CONNECTED to SA_MATURE.
19 On Access Point #2/ Device #2, repeat the same procedure. However, replace Access Point #2
information with Access Point #1 information.
20 Once both tunnels are established, ping each side of the tunnel to ensure connectivity.

Configuring a Cisco VPN Device

This section includes general instructions for configuring a Cisco PIX Firewall 506 series device.
For the usage scenario described in this section, you will require the following:
1 Cisco VPN device
●
1 PC connected to the LAN side of the Access Point and the Cisco PIX.
●
NOTE
The Cisco PIX device configuration should match the Access Point VPN configuration in terms of Local
WAN IP (PIX WAN), Remote WAN Gateway (Access Point WAN IP), Remote Subnet (Access Point LAN Subnet),
and the Remote Subnet Mask. The Auto Key Settings and the IKE Settings on the Cisco PIX should match the
Access Point Key and IKE settings.
Altitude 4700 Series Access Point Product Reference Guide
641