Ap4700>Admin(Network.wireless.radio)>Set - Extreme Networks Altitude 4700 Series Product Reference Manual

AP4700>admin(network.wireless.radio)>set
Sets the access point's radio configuration and defines the RF band of operation.
Syntax
set radio-config
max-mus
mesh-base
mesh-max
mesh-client
mesh-roaming-client
mesh-timeout
mesh-wlan
dot11-auth
qos-mapping
(wired-to-wireless)
Example
admin(network.wireless.radio)>set max-mus 127
admin(network.wireless.radio)>set mesh-base 1 enable
admin(network.wireless.radio)>set mesh-max 1 11
admin(network.wireless.radio)>set mesh-client 1 disable
admin(network.wireless.radio)>set mesh-roaming-client 1 enable
admin(network.wireless.radio)>set mesh-wlan wlan1
admin(network.wireless.radio)>set dot11-auth shared-key-allowed
CAUTION
A 40 MHz channel is composed of two 20 MHz subchannels. If the firmware detects radar within the FCC
80 % detection band of the 40 MHz channel; the device must vacate the channel. If the detected signal falls outside
the FCC 80 % detection band of one of the 20 MHz subchannels; the Master Device can legally move to that 20
MHz channel.
Three Radio SKU
set radio-config <value 1-8>
Altitude 4700 Series Access Point Product Reference Guide
<mode> Sets the radio configuration. The options available differ
depending on the single, dual or three radio configuration
deployed (see examples below).
<mus>> Defines the maximum number of MUs assigned to the specified
radio (idx 1 or 2). The range can be defined between 0 and 127.
This command does not apply to single radio access points.
<mode> Enables or disables base bridge mode.
<clients> Sets the maximum number of wireless bridge clients.
<mode> Enables or Disables client bridge mode.
<mode> Enables or disables the mesh roaming client mode. For
information on the Mesh Roaming Client feature, see
Roaming Client" on page
<mode> Sets the client bridge link timeout.
<name> Defines the client bridge WLAN name.
<auth- Defines dot11 level authentication algorithm to either
algorithm> system-only or shared-key-allowed.
<mode> Sets the QoS mapping from wired to wireless.
1 Radio 1 WLAN, Radio 2 WLAN, Radio 3 WIPS
2 Radio 1 WLAN, Radio 2 WIPS, Radio 3 WIPS
3 Radio 1 WIPS, Radio 2 WLAN, Radio 3 WIPS
4 Radio 1 WLAN, Radio 2 WLAN, Radio 3 Disabled
5 Radio 1 WIPS, Radio 2 WIPS, Radio 3 Disabled
6 Radio 1 WLAN, Radio 2 Disabled, Radio 3 Disabled
25.
"Mesh
open-
391