Ap4700>Admin(System.snmp.access)>Add - Extreme Networks Altitude 4700 Series Product Reference Manual

CLI Reference
AP4700>admin(system.snmp.access)>add
Adds SNMP access entries for specific v1v2 and v3 user definitions.
Syntax
add acl <ip1> <ip2>
v1v2c <comm> <access>
v3 <user> <access>
<auth> <pass1>
For information on configuring SNMP access settings using the applet (GUI), see
Access Control" on page
494
Adds an entry to the SNMP access control list with <ip1> as the starting IP
address and <ip2> and as the ending IP address.
<oid>
: comm - community string 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
<oid> <sec>
<priv> <pass2>
: user - username 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
: sec - security - (none,auth,auth/priv)
: auth - algorithm - (md5,sha1)
: (required only if sec is - auth,auth/priv)
: pass1 - auth password - 8 to 31 chars
: (required only if sec is 'auth,auth/priv')
: priv - algorithm - (des, aes)
: (required only if sec is 'auth/priv')
: pass2 - privacy password - 8 to 31 chars
: (required only if sec is 'auth/priv')
The following parameters must be specified if <sec> is not none:
Authentication type <auth> set to md5 or sha1
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password <pass2> (8 to 31 chars)
101.
Altitude 4700 Series Access Point Product Reference Guide
"Configuring SNMP