Install The Access Point On A Wall - Extreme Networks ExtremeWireless AP5050D Installation Manual

Install the Access Point on a Wall

Table 14: AP5050D Mounting Bracket Usage (continued)
Mounting bracket and Unistrut install
part number
Yes No
30520 No
(WS-MBO-POLE01
bracket)
Warning
When installing the access point on a wall or to a pole, the cable glands must face down.
Note
When using the MBO-ART02 articulating mounting bracket with the access point, set the
bracket downward tilt to less than 20 degrees to prevent water ingress.
Install the Access Point on a Wall
Before You Begin
Combine the access point with the KT-147407-02 and KT-150173-01 for wall or flat surface installation.
Other wall install options include using the:
•
MBO-ART02 bracket
The following hardware is required when installing the access point on a flat surface using the
KT-147407-02 bracket:
•
One access point
•
Flat part of the KT-147407-02 bracket with two holes on the metal surface.
20 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point
Wall install Pole install
No The unistrut
mounting bracket
is paired with the
POLE01 bracket
for pole
installations.
For wall
installations, the
wall must be
strong enough to
support the access
point during
inclement weather
No Yes (must be used
with the MBO-
ART02 bracket)
Install the Access Point
Notes
If the pole diameter is <= 1.0
in. (25.4 mm), use small cable
clamp. If the pole diameter is
between 5.0 in. - 7.0 in. (178.0
mm), use large cable clamp. For
any other pole diameter, provide
your own stainless steel cable
clamp. The band must be 0.5 in.
(12.7 mm) wide
The POLE01 bracket can be used
only when paired with the MBO-
ART02 bracket