Install The Access Point On A Wall Or A Flat Ceiling; Install The Access Point On A Silhouette Ceiling - Extreme Networks ExtremeWireless AP3000X Installation Manual

Install the Access Point on a Wall or a Flat Ceiling

Table 18: Hardware (continued)
Quantity
1
2
2
Install the Access Point on a Wall or a Flat Ceiling
Before You Begin
Confirm that you have the following items:
•
An AP3000X access point
•
One AH-ACC-BKT-AX-TB mounting bracket. The bracket is used for flat surface wall
or solid ceiling installation.
•
Two M3.5 pan head wood screws and two screw-in anchors.
About This Task
Follow these steps when you install the access point on a wall or solid ceiling.
Procedure
1. Mark and drill two mounting holes.
Use the AH-ACC-BKT-AX-TB mounting bracket as a template.
2. Attach the bracket to the wall.
Use the two M3.5 pan head screws. Use push-in anchors or screw-in anchors for
drywall or plastic board installations.
3. Attach the access point to the bracket
Align the red dots on the bracket and the access point base.
4. Press and rotate the AP one-sixth turn clockwise.
The AP clicks into place on the bracket.
5. Attach the network cable and power-up the AP.
•
If you use Power over Ethernet (PoE) then attach the network cable to the ETH0
port.
•
If you use Power Sourcing Equipment (PSE), then connect the power supply and
attach the network cable to the ETH0 port.

Install the Access Point on a Silhouette Ceiling

Before You Begin
You need the following items:
•
AP3000X
•
AH-ACC-BKT-AX-SL bracket
22 ExtremeWireless™ AP3000X Access Point Installation Guide
Item
AH-ACC-BKT-AX-TB mounting bracket
Phillips pan head wood screws
Screw-in anchors
Access Point Installation