Ap4700>Admin(System.snmp.traps)>Add - Extreme Networks Altitude 4700 Series Product Reference Manual

CLI Reference
AP4700>admin(system.snmp.traps)>add
Adds SNMP trap entries.
Syntax
add v1v2 <ip> <port>
Adds an entry to the SNMP v1/v2 access list with the destination IP address set to <ip>, the
destination UDP port set to <port>, the community string set to <comm> (1 to 31 characters), and the
SNMP version set to <ver>.
v3 <ip> <port>
Adds an entry to the SNMP v3 access list with the destination IP address set to <ip>, the destination
UDP port set to <port>, the username set to <user> (1 to 31 characters), and the authentication type
set to one of none, auth, or auth/priv.
The following parameters must be specified if <sec> is not none:
Authentication type <auth> set to md5 or sha1
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password <pass2> (8 to 31 chars)
Example
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index dest ip
----------------------------------------------------------------------
1 203.223.24.2
admin(system.snmp.traps)>add v3 201.232.24.33 555 BigBoss none md5
admin(system.snmp.traps)>list v3 all
index
destination ip
destination port
username
security level
auth algorithm
auth password
privacy algorithm
privacy password
For information on configuring SNMP traps using the applet (GUI), see
Thresholds" on page 107.
500
<comm> <ver>
<user> <sec> <auth>
dest port community
333 mycomm
: 1
: 201.232.24.33
: 555
: BigBoss
: none
: md5
: ********
: des
: ********
Altitude 4700 Series Access Point Product Reference Guide
<pass1> <priv> <pass2>
version
v1
"Configuring SNMP RF Trap