Table of Contents
Advertisement
System Configuration
2 Configure the RF Trap Thresholds field to define device threshold values for SNMP traps.
NOTE
Average Bit Speed,% of Non-Unicast, Average Signal, Average Retries,% Dropped and %
Undecryptable are not Access Point statistics.
Pkts/s
Throughput
Average Bit Speed
Average Signal
Average Retries
% Dropped
% Undecryptable
Associated MUs
3 Configure the Minimum Packets field to define a minimum packet throughput value for trap
generation.
Minimum number
of packets required
for a trap to fire
4 Click Apply to save any changes to the SNMP RF Traps screen. Navigating away from the screen
without clicking the Apply button results in all changes to the screen being lost.
5 Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the settings
displayed on SNMP RF Traps screen to the last saved configuration.
6 Click Logout to securely exit the access point Access Point applet. A prompt displays confirming the
logout before the applet is closed.
Configuring LLDP Settings
LLDP is a Layer 2 protocol (IEEE standard 802.1AB) used to determine the capabilities of devices such
as repeaters, bridges, Access Points, routers and wireless clients. LLDP enables devices to advertise their
capabilities and media-specific configurations.
LLDP provides a method of discovering and representing the physical network connections of a given
network management domain. The LLDP neighbor discovery protocol allows you to discover and
maintain accurate network topologies in a multivendor environment.
108
Enter a maximum threshold for the total throughput in Pps
(Packets per second).
Set a maximum threshold for the total throughput in Mbps
(Megabits per second).
Enter a minimum threshold for the average bit speed in
Mbps (Megabits per second).
Enter a minimum threshold for the average signal strength
in dBm for each device.
Set a maximum threshold for the average number of
retries for each device.
Enter a maximum threshold for the total percentage of
packets dropped for each device. Dropped packets can be
caused by poor RF signal or interference on the channel.
Define a maximum threshold for the total percentage of
packets undecryptable for each device. Undecryptable
packets can be the result of corrupt packets, bad CRC
checks or incomplete packets.
Set a maximum threshold for the total number of MUs
associated with each device.
Enter the minimum number of packets that must pass
through the device before an SNMP rate trap is sent.
Extreme Networks recommends using the default setting of
1000 as a minimum setting for the field.
Altitude 4700 Series Access Point Product Reference Guide
Advertisement
Table of Contents
