Installing The Power Injector - Extreme Networks Altitude 4700 Series Product Reference Manual

point's GE1/POE port. The Power Injector is a separately ordered component and not shipped with an
existing access point SKU.
An AP4700 access point can also be used with the 3af power injector (AP-PSBIAS-1P2-AFR). However,
AP functionality is limited when powered by an AP-PSBIAS-1P2-AFR, since the AP has Ethernet
connectivity limited to only the GE1 port.
Extreme Networks is reselling Motorola Power Supply (Part No. 50-14000-247R) as an accessory for
AP4700.
CAUTION
The access point supports any standards-based compliant POE sources (802.3at and 802.3af). Using a
non-standard based solution could either limit functionality or severely damage the access point and void the
product warranty.
A separate Power Injector is required for each access point comprising the network.

Installing the Power Injector

Refer to the following sections for information on planning, installing, and validating the installation:
Preparing for Site Installation on page 50
●
Cabling the Power Injector on page 50
●
Altitude 4700 Series Access Point Product Reference Guide
49