Extreme Networks Altitude 4700 Series Product Reference Manual page 56

Hardware Installation
Safety wire (strongly recommended)
●
Security cable (optional)
●
To install the Access Point above a ceiling:
1 If possible, remove the adjacent ceiling tile from its frame and place it aside.
2 Install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in diameter, in the ceiling space.
3 If required, install and attach a security cable to the Access Point's lock port.
4 Mark a point on the finished side of the tile where the light pipe is to be located.
5 Create a light pipe path hole in the target position on the ceiling tile.
6 Use a drill to make a hole in the tile the approximate size of the LED light pipe.
CAUTION
Extreme Networks recommends care be taken not to damage the finished surface of the ceiling tile
when creating the light pipe hole and installing the light pipe.
7 Remove the light pipe's rubber stopper before installing the light pipe.
8 Connect the light pipe to the bottom of the Access Point. Align the tabs and rotate approximately 90
degrees. Do not over tighten.
9 Fit the light pipe into hole in the tile from its unfinished side.
10 Place the decal on the back of the badge and slide the badge onto the light pipe from the finished
side of the tile.
11 Attach the radio antennas to their correct connectors. For more information on available antennas,
see "Antenna Options" on page
12 Extreme Networks recommends attaching safety wire to the Access Point's safety wire tie point or
security cable (if used) to the Access Point's lock port.
13 Align the ceiling tile into its former ceiling space.
14 Cable the Access Point using an approved line cord and power supply.
56
47.
Altitude 4700 Series Access Point Product Reference Guide