Extreme Networks Altitude 4700 Series Product Reference Manual page 155

Either the New MU ACL Policy or Edit MU ACL Policy screen displays.
3 Assign a name to the new or edited ACL policy that represents an inclusion or exclusion policy
specific to a particular type of MU traffic you may want to use with a single or group of WLANs.
More than one WLAN can use the same ACL policy.
4 Configure the parameters within the Mobile Unit Access Control List field to allow or deny MU access
to the access point.
The MU adoption list identifies MUs by their MAC address. The MAC address is the MU's unique
Media Access Control number printed on the device (for example, 00:09:5B:45:9B:07) by the
manufacturer. A maximum of 200 MU MAC addresses can be added to the New/Edit MU ACL
Policy screen.
Access for the
listed Mobile Units
Add
Delete
5 Click Apply to save any changes to the New MU ACL Policy or Edit MU ACL Policy screen and
return to the Mobile Unit Access Control List Configuration screen. Navigating away from the screen
without clicking Apply results in changes to the screens being lost.
6 Click Cancel to securely exit the New MU ACL Policy or Edit MU ACL Policy screen and return to
the Mobile Unit Access Control List Configuration screen.
7 Click Logout within the Mobile Unit Access Control List Configuration screen to securely exit the
Access Point applet. A prompt displays confirming the logout before the applet is closed.
Altitude 4700 Series Access Point Product Reference Guide
Use the drop-down list to select Allow or Deny. This rule
applies to the MUs listed in the table. For example, if the
adoption rule is to Allow, access is granted for all MUs
except those listed in the table.
Click the Add button to create a new entry using only the
Start MAC column to specify a MAC address, or uses both
the Start MAC and End MAC columns to specify a range
of MAC addresses.
Click the Delete button to remove a selected list entry.
155