See Also
Installing an M120 PIC
Copyright © 2018, Juniper Networks, Inc.
Figure 89: Removing an M120 PIC
M120 PICs Description on page 57
Maintaining M120 PICs and PIC Cables on page 275
Troubleshooting M120 PICs on page 288
Installing an M120 PIC on page 225
To install a PIC (see
Figure 90 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
If the PIC uses fiber-optic cable, verify that there is a rubber safety cap over each
2.
transceiver on the faceplate. Install a cap if necessary.
Align the notches in the connector at the rear of the PIC with the notches in the PIC
3.
slot in the FPC and then slide the PIC in until it lodges firmly in the FPC.
CAUTION:
Slide the PIC straight into the slot to avoid damaging the
components on the bottom of the PIC.
Chapter 27: Replacing Line Card Components
227):
225