Verifying The Installation; Configuring Line Module Redundancy; The Next Step - Juniper E Series Hardware Manual

Verifying the Installation

To verify that the installation is complete:
1. After you have cabled the system for power (see Chapter 6, Cabling E-series
2. Issue the show redundancy command, and verify that the display shows the

Configuring Line Module Redundancy

For information about configuring line module redundancy, refer to
Basics Configuration Guide, Chapter 5, Managing Line Modules and SRP

The Next Step

After you install the modules, you can connect cables to the system. Turn to
Chapter 6, Cabling E-series Routers.
Routers), turn on the power switches.
The system reboots.
redundancy hardware.
Chapter 5: Installing Modules
JUNOSe System
Modules.

Configuring Line Module Redundancy

! 53