Chapter 29 User Access Management Configuration - Juniper JUNOS OS 10.3 - SOFTWARE Manual

CHAPTER 29
User Access Management Configuration
Configuring Management Access for the EX Series Switch (J-Web Procedure)
Copyright © 2010, Juniper Networks, Inc.
Configuring Management Access for the EX Series Switch (J-Web
Procedure) on page 495
Generating SSL Certificates to Be Used for Secure Web Access on page 498
Configuring MS-CHAPv2 to Provide Password-Change Support (CLI
Procedure) on page 499
You can manage an EX Series switch remotely through the J-Web interface. To
communicate with the switch, the J-Web interface uses Hypertext Transfer Protocol
(HTTP). HTTP allows easy Web access but no encryption. The data that is transmitted
between the Web browser and the switch by means of HTTP is vulnerable to interception
and attack. To enable secure Web access the switch supports HTTP over Secure Sockets
Layer (HTTPS). You can enable HTTP or HTTPS access on specific interfaces and ports
as needed.
Navigate to the Secure Access Configuration page by selecting
>
Properties Management Access
on interfaces for managing the EX Series switch through the J-Web interface. You can
also install SSL certificates and enable Junos XML management protocol over SSL with
the Secure Access page.
Click to modify the configuration. Enter information into the Management Access
Edit
1.
Configuration page as described in Table 99 on page 496.
To verify that Web access is enabled correctly, connect to the switch using the
2.
appropriate method:
For HTTP access—In your Web browser, type
For HTTPS access—In your Web browser, type
For SSL Junos XML management protocol access—To use this option, you must
have a Junos XML management protocol client such as Junos Scope. For information
about how to log into Junos Scope, see the Junos Scope Software User Guide.
. On this page, you can enable HTTP and HTTPS access
http://URL
https://URL
>
Configure System
or .
http://IP address
or https://IP address .
495