Juniper JUNOS OS 10.3 - SOFTWARE Manual page 1058

Complete Software Guide for Junos
Meaning
Troubleshooting
Problem
Solution
Problem
Solution
962
®
OS for EX Series Ethernet Switches, Release 10.3
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
The show virtual-chassis vc-port all-members
interfaces that are enabled for the member switches of the Virtual Chassis configuration
and shows the status of the interfaces. In this case, no VCP uplinks have been configured.
However, the VCP interfaces are automatically configured and enabled when you
interconnect member switches using the dedicated VCPs. There are two dedicated VCPs
on the rear panel of each EX4200 switch. The dedicated VCP interfaces are identified
simply as vcp-0 and vcp-1. They do not use the standard interface address (in which the
member ID is represented by the first digit). The output in this example shows that all
interfaces are operational. The
To troubleshoot the configuration of a multimember Virtual Chassis in a single wiring
closet, perform these tasks:
Troubleshooting Mastership Priority
You want to explicitly designate one member as the master and another as backup.
Change the mastership priority value of the member that you want to function as master,
designating the highest mastership priority value that member.
NOTE: These configuration changes are made through the current master,
SWA-0.
Configure mastership priority of member 0 to be the highest possible value.
1.
[edit virtual-chassis]
user@SWA-0# set member 0 mastership-priority 255
Set the mastership priority of another member that you want to function as the backup
2.
member as the same value:
[edit virtual-chassis]
user@SWA-0# set member 2 mastership-priority 255
Troubleshooting Nonoperational VCPs
The VCP interface shows a status of
Check the cable to make sure that it is properly and securely connected to the VCPs.
Status
Up
Up
command lists the Virtual Chassis
fpc number is the same as the member ID.
.
down
Copyright © 2010, Juniper Networks, Inc.