Juniper JUNOS OS 10.3 - SOFTWARE Manual page 453

Additional Information
Required Privilege
Level
List of Sample Output
Copyright © 2010, Juniper Networks, Inc.
—(EX4200 switches only) (Optional) Display standard information
member member-id
about the hostname and version of the software running on the specified member
of the Virtual Chassis configuration. Replace
9.
—(TX Matrix routers only) (Optional) Display the hostname and version information
scc
about the software running on the TX Matrix router (or switch-card chassis).
sfc number —(TX Matrix Plus routers only) (Optional) Display the hostname and version
information about the software running on the TX Matrix Plus router (or switch-fabric
chassis). Replace number with
By default, when you issue the
master Routing Engine, the command is broadcast to all the T640 (in a routing matrix
based on a TX Matrix router) or T1600 (in a routing matrix based on a TX Matrix Plus
router) master Routing Engines connected to it. Likewise, if you issue the same command
on the TX Matrix or TX Matrix Plus backup Routing Engine, the command is broadcast
to all the T640 (in a routing matrix based on a TX Matrix router) or T1600 (in a routing
matrix based on a TX Matrix Plus router) backup Routing Engines that are connected to
it.
view
show version on page 358
show version (TX Matrix Plus Router) on page 358
Chapter 17: Operational Mode Commands for System Setup
member-id
.
0
show version command on a TX Matrix or TX Matrix Plus
with a value from 0 through
357