Complete Software Guide for Junos
410
®
OS for EX Series Ethernet Switches, Release 10.3
NOTE: Interfaces
ports. Optional uplink modules provide four 10-gigabit small form-factor
pluggable (SFP+) transceivers (
small form-factor pluggable (SFP) transceivers (
Although you can install only one uplink module, the interfaces for both are
shown below.
When you commit changes to the configuration, a new configuration file is created, which
becomes the active configuration. You can always revert to the factory default
configuration. See "Reverting to the Default Factory Configuration for the EX Series
Switch" on page 427.
This topic shows the factory default configuration file of an EX4500 switch:
system {
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
commit {
factory-settings {
reset-chassis-lcd-menu;
reset-virtual-chassis-configuration;
}
}
}
interfaces {
xe-0/0/0 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/1 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/2 {
unit 0 {
family ethernet-switching;
}
}
xe-0/0/3 {
unit 0 {
through
xe-0/0/0
xe-0/0/39
xe-0/1/0
through
Copyright © 2010, Juniper Networks, Inc.
are the network interface
xe-0/1/3
) or four 1-gigabit
through
xe-0/2/0
xe-0/2/3
).