Configuring Service Logging (Web Interface); Access Log Configuration; Access Log Copy/Auto Download Configuration; Figure 60 Log Configuration Page Detail (Access Log Configuration) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide

Configuring Service Logging (Web Interface)

Set Media Flow Controller Access Log and Stream Log options, including automatic upload.

Access Log Configuration

The Accesslog records each HTTP transaction going through Media Flow Controller. See
"Service Log (accesslog)" on page 212
To configure the accesslog:
1. Enter this information to the text boxes or select the checkbox as described:
• Enable—Enable access logging; this records all user activity on the system. The no
variant disables. Default is enabled.
• Syslog Replicate Enable—Specify whether or not the access log messages are
seen as part of SYSLOG also. By default the option is disabled (access log is not
seen as part of SYSLOG).
• Log Format—Specify the format in which access log is to be obtained. See
accesslog
2. Click Apply.
3. Click Save at the top of the page to make changes persistent across reboots.
Figure 60 Log Configuration Page Detail (Access Log Configuration)

Access Log Copy/Auto Download Configuration

Set automatic uploading of the accesslog. See
To download the accesslog:
1. Enter this information to the text boxes:
• URL—The URL to which the accesslog should be downloaded when it reaches the
download trigger size, by default when filesize reaches 100MB; this can be changed
using the CLI, see
• Password—The password needed for the download.
2. Click Apply.
Media Flow Controller Configuration Tasks (Web Interface)
for details. See
for CLI details on log formatting.
accesslog for details.
Figure 60.
Figure 61.
Configuring Service Logging (Web Interface) 187