Table of Contents
Advertisement
Related
Documentation
Understanding Global Management of a Virtual Chassis Configuration
Copyright © 2010, Juniper Networks, Inc.
A new software release can be upgraded to the entire Virtual Chassis configuration or to
a particular member in the Virtual Chassis configuration through a CLI or J-Web command.
A user can add software packages to either a single member of the Virtual Chassis
configuration or to all members of the Virtual Chassis configuration at the same time.
Virtual Chassis Overview on page 921
Understanding Virtual Chassis Components on page 924
Understanding Automatic Software Update on Virtual Chassis Member Switches on
page 945
Installing Software on an EX Series Switch with a Single Routing Engine (CLI Procedure)
on page 78
A Virtual Chassis configuration is composed of multiple Juniper Networks EX4200 Ethernet
Switches, so it has multiple console ports and multiple out-of-band management Ethernet
ports located on the rear panels of the switches.
You can connect a PC or laptop directly to a console port of any member switch to set
up and configure the Virtual Chassis. When you connect to the console port of any member
switch, the console session is redirected to the master switch, as shown in Figure 9 on
page 930.
Chapter 43: Virtual Chassis—Overview, Components, and Configurations
929
Advertisement
Chapters
Table of Contents
Troubleshooting
