Juniper JUNOS OS 10.3 - SOFTWARE Manual page 393

Additional Information
Required Privilege
Level
List of Sample Output
show system reboot show system reboot
Copyright © 2010, Juniper Networks, Inc.
—(EX4200 switches only) (Optional) Display halt or reboot request information for
local
the local Virtual Chassis member.
member member-id —(EX4200 switches only) (Optional) Display halt or reboot request
information for the specified member of the Virtual Chassis configuration. Replace
with a value from 0 through 9.
member-id
—(TX Matrix router only) (Optional) Display halt or reboot request information for
scc
the TX Matrix router (or switch-card chassis).
—(TX Matrix Plus router only) (Optional) Display halt or reboot request information
sfc
for the TX Matrix Plus router (or switch-fabric chassis).
By default, when you issue the
Matrix Plus master Routing Engine, the command is broadcast to all the T640 (in a
routing matrix based on the TX Matrix router) or T1600 (in a routing matrix based on the
TX Matrix Plus router) master Routing Engines connected to it. Likewise, if you issue the
same command on the TX Matrix or TX Matrix Plus backup Routing Engine, the command
is broadcast to all the T640 (in a routing matrix based on the TX Matrix router) or T1600
(in a routing matrix based on the TX Matrix Plus router) backup Routing Engines that are
connected to it.
maintenance
show system reboot on page 297
show system reboot all-lcc (TX Matrix Router) on page 298
show system reboot sfc (TX Matrix Plus Router) on page 298
user@host> show system reboot
reboot requested by root at Wed Feb 10 17:40:46 1999
[process id 17885]
Chapter 17: Operational Mode Commands for System Setup
show system reboot command on a TX Matrix or TX
297